Audionet ART G3 Uživatelský manuál stáhnout pdf (Strana 9)

4 Installation and power supply

Important

· During connecting or removing the ART G3 to/from a preampli-

fier both units and the corresponding power amplifiers have to be

switched off to prevent damage of the ART G3 or any of the

other connected units.

· Please make sure that all cables are in absolute best conditions!

Broken shields or short-cut cables could damage the ART G3

and/or any other connected unit.

4.1 Placement

Important

· It is recommended to place the ART G3 into a high quality rack or

onto a stable table.

· Do not expose the unit to direct sunlight.

· Do not place the ART G3 in close range to heat sources like radia-

tors.

· Do not place the ART G3 on top of other units, especially not on top

of power amplifiers, preamplifiers or similar that produce heat. Both

units could suffer damage from thermal overload.

· Do not use the unit in a place where it is exposed to vibrations.

· Do not place the unit close to loudspeakers or into the corner of a

room where it is exposed to high levels of sonic energy, which might

reduce the sound quality of the unit.

4.2 Mains connection

The mains input 12

is on the back panel of the ART G3. To connect the

unit to mains use the included mains cord. If you prefer to use a different

power cord make sure that it meets the specifications for your home

country.

see numbers in section 'Overview back panel' on page 8.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 53 54

Žádné komentáře

Audionet ART G3 Uživatelský manuál Strana 9